From

Once the Add Fields button has been clicked and a new row added to the table, click the Ellipses button in the 'From' column to select the source field from which data should be transferred.

To

Once the source field has been selected (in the 'From' column), click the Ellipses button in the 'To' column to select the destination field to which the data should be transferred.

Add Fields

Click this Add Fields button to add a new row to the fields source and destination table.

Remove Fields

Click this Remove Fields button to remove a row from the fields source and destination table.

Summary

Auto-Summary

Auto-summary refers to the text that will be shown on the command in the Behaviors canvas. By default, this check box is selected.

For commands that use a condition or calculation, Auto-Summary will display the formula selected in the Condition Properties. If no condition exists, nothing will be displayed.

If you wish to have other summary text display, clear the Auto-summary check box and type the custom text in the list box below. Your text will be retained if you later decide to enable Auto-summary.

[Summary Text}

This is where manual summary text can be entered when the Auto-summary option is not turned on.