[Name Text]

Enter a descriptive name for this path. Text entered here shows as the path label on the diagram.

Condition

Always, if No Other Condition is Met

Select this radio button to set a condition that causes the workflow to follow the path. This option is the default setting for new paths. This condition indicates that the path will always run when the form is submitted unless an alternative path’s condition is met.

Workflow Path Conditions

Simple

Select this radio button to set a simple condition on the path that is dependent on a value in a field on the form.

Click Select to choose the form field or object for the condition. Once a selection has been made, the value will be shown in the read-only text box to the left of the Select button.

Select the operation from the drop-down list that will run against the field. Options include:

Enter the alphanumeric value you want to compare against.

Note: If the selected operation is 'is checked' or 'is not checked', this field will be disabled.

Advanced

Select this radio button to compose your own conditional formula that must be satisfied for the path to continue.

Click the Edit button to open the Formula and Conditions Editor.

Using the Formula and Condition Editor

Caption Box Width

Enter the width (in pixels) for the box containing the caption text. The width defaults to 80 pixels. This box is displayed on the path object in the Workflow canvas.

Edit button

Click the Edit button to add behavior commands specific to the path. This loads the Behaviors view. The Workflow Commands section of the Behaviors Toolbox will contain commonly used workflow behaviors such as Notify and Set Stage.

Behaviors Reference - Workflow Commands

Remove button

Click the Remove button to remove existing behavior commands.