All

Select this radio button to assign all pages in the form to be printed when the Print command runs.

Current

Select this radio button to assign the active page of the form to be printed when the Print command runs.

Specific

Select this radio button to assign only the pages selected in the list box below the 'Specific' radio button to be printed when the Print command runs. One or more pages can be selected by holding the CTRL button and clicking on the pages to be included.

Sections

[Section Selection]

Select which sections will print when the Print command runs (in addition to the pages specified in the 'Pages' section). Options include:

Appendix Size

[Appendix Size Selection]

Select the page size for the appendix. Options include:

Width

Specify the width of the printed appendix.

Unit

Select inches or other dimension units to help determine  the size of the printed appendix.

Height

Specify the height of the printed appendix.

DPI

Specify the resolution of the printed appendix in dots per inch.

Summary

Auto-Summary

Auto-summary refers to the text that will be shown on the command in the Behaviors canvas. By default, this check box is selected.

For commands that use a condition or calculation, Auto-Summary will display the formula selected in the Condition Properties. If no condition exists, nothing will be displayed.

If you wish to have other summary text display, clear the Auto-summary check box and type the custom text in the list box below. Your text will be retained if you later decide to enable Auto-summary.

[Summary Text}

This is where manual summary text can be entered when the Auto-summary option is not turned on.