Object

[Object Selection]

Click Select to choose the object you want to show when the Show command runs.

To select the desired object, click the Select button, then navigate to the object you want to choose. Once a selection has been made, the value will be shown in the read-only text box to the left of the Select button.

Summary

Auto-Summary

Auto-summary refers to the text that will be shown on the command in the Behaviors canvas. By default, this check box is selected.

For commands that use a condition or calculation, Auto-Summary will display the formula selected in the Condition Properties. If no condition exists, nothing will be displayed.

If you wish to have other summary text display, clear the Auto-summary check box and type the custom text in the list box below. Your text will be retained if you later decide to enable Auto-summary.

[Summary Text]

This is where manual summary text can be entered when the Auto-summary option is not turned on.