Next

Select this radio button to have the form progress to the next page when the Show Page command runs.

Previous

Select this radio button to have the form return to the previous page when the Show Page command runs.

Back to Last Shown

Select this radio button to have the form return to the last page that was shown when the Show Page command runs.

Specific

Select this radio button to assign a specific page of the form to load when the Show Page command runs. Select the page to be displayed from the drop-down list to the right of the 'Specific' radio button.

Summary

Auto-Summary

Auto-summary refers to the text that will be shown on the command in the Behaviors canvas. By default, this check box is selected.

For commands that use a condition or calculation, Auto-Summary will display the formula selected in the Condition Properties. If no condition exists, nothing will be displayed.

If you wish to have other summary text display, clear the Auto-summary check box and type the custom text in the list box below. Your text will be retained if you later decide to enable Auto-summary.

[Summary Text}

This is where manual summary text can be entered when the Auto-summary option is not turned on.