Condition

Simple

Select this radio button to set a simple condition based on a form field that must be satisfied for the behavior to continue to the next branch.

Simple Branch or Multiple Branch

Click Select to choose the form field or object for the condition. Once a selection has been made, the value will be shown in the read-only text box to the left of the Select button.

Select the operation from the drop-down list that will run against the field. Options include:

Enter the alphanumeric value you want to compare against.

Note: If the selected operation is 'is checked' or 'is not checked', this field will be disabled.

Advanced

Select this radio button to compose your own conditional formula that must be satisfied for the path to continue.

Click the Edit button to open the Formula and Conditions Editor.

Summary

Auto-Summary

Auto-summary refers to the text that will be shown on the command in the Behaviors canvas. By default, this check box is selected.

For commands that use a condition or calculation, Auto-Summary will display the formula selected in the Condition Properties. If no condition exists, nothing will be displayed.

If you wish to have other summary text display, clear the Auto-summary check box and type the custom text in the list box below. Your text will be retained if you later decide to enable Auto-summary.

[Summary Text]

This is where manual summary text can be entered when the Auto-summary option is not turned on.