Object

[Object Selection]

Click Select to choose the timer, movie or sound object you want to start or stop when the command runs.

To select the desired object, click the Select button, then navigate to the object you want to choose. (The OK button on the 'Select an Object' dialog will remain disabled until you've selected a timer, movie or sound object.)

Once a selection has been made, the value will be shown in the read-only text box to the left of the Select button.

Action

Start

Select this radio button to have the object start playback when the Start/Stop command runs.

Stop

Select this radio button to have the object stop playback when the Start/Stop command runs.

Continue

Select this radio button to have the object continue playback when the Start/Stop command runs.

Summary

Auto-Summary

Auto-summary refers to the text that will be shown on the command in the Behaviors canvas. By default, this check box is selected.

For commands that use a condition or calculation, Auto-Summary will display the formula selected in the Condition Properties. If no condition exists, nothing will be displayed.

If you wish to have other summary text display, clear the Auto-summary check box and type the custom text in the list box below. Your text will be retained if you later decide to enable Auto-summary.

[Summary Text]

This is where manual summary text can be entered when the Auto-summary option is not turned on.